How to Use a Ceramic Lotus Backflow Incense Burner

Quick Answer

To use a ceramic lotus backflow incense burner, place a backflow cone on the top hole, light it, and let the smoke cascade down the lotus petals. Always use backflow-specific cones and keep the burner on a flat, heat-resistant surface.

Step-by-Step: Using Your Ceramic Lotus Backflow Burner

1. Set Up the Burner: Place the burner on a flat, heat-resistant surface. Ensure the top hole is clear of debris. Check that the surface is level before lighting.
2. Light the Backflow Cone: Hold a backflow cone at a slight angle and light the tip. Let it burn for 5-10 seconds, then blow out the flame. You should see a glowing ember and a thin wisp of smoke. If the smoke is too thick or the cone goes out, relight and let it burn a bit longer.
3. Place the Cone on the Burner: Gently set the cone on the top hole of the lotus burner, making sure the hole in the cone aligns with the burner's hole. Do not force it. Proper alignment is key; a misaligned cone can block the smoke flow.
4. Observe the Waterfall Effect: Wait a few seconds for the smoke to start flowing down the lotus petals. Enjoy the calming visual. If the smoke rises instead of falling, the cone is not a backflow type or the burner is not level.
5. Extinguish Safely: After use, let the cone burn out completely on its own, or carefully extinguish it with a snuffer or by dipping in water. Clean the burner once cool. Never leave a burning cone unattended.

Product Spotlight

• Ceramic Lotus Backflow Incense Burner: This ceramic lotus burner uses backflow technology to create a stunning waterfall of smoke. The lotus design not only looks elegant but also guides the smoke down the petals, making the visual effect more pronounced and relaxing.